Amazone GreenDrill GD200-E - Calibration by Comparing the Speedometer; Enter the Calibration Value Manually

GreenDrill control terminal 5.2
GreenDrill BAH0054-9 11.17
77
7.7.2 Calibration by comparing the speedometer
1. Select the display with the buttons.
2. Confirm the selection with the
button.
3. Select the display with the buttons.
4. Confirm the display with the
button.
5. Start the tractor for the calibration run.
During the calibration run, compare the speeds shown on the
display with those on the tractor's speedometer.
Correct the value using the
buttons, until both val-
ues are the same.
7.7.3 Enter the calibration value manually
1. Select the display with the buttons.
2. Confirm the selection with the
button.
3. Select the display with the buttons.
4. Confirm the display with the
button.
5. If known, enter the calibration value with the buttons,
e.g., "13000" for 13000 [pulses/100 m].