GreenDrill control terminal 5.2
66
GreenDrill BAH0054-9 11.17
7.3 Main menu
7.3.1 During operation - Display without speed sensor
Line 1 in the main menu shows
the seeding shaft speed [%] set for calibration.
Line 2 in the main menu shows
the forward speed [km/h] set for calibration.
The seeding shaft speed is not adjusted for chang-
ing forward speeds. Always maintain the indicated
forward speed [km/h] during operation.
7.3.2 During operation - Display with speed sensor
Line 1 in the main menu shows the seeding
shaft speed [%]
Setpoint 50 %
Actual value 25 %
Line 2 in the main menu shows the forward
speed [km/h]
Setpoint 20 km/h
Actual value 10 km/h
Display Setpoint Actual value
Seeding shaft speed [%] The target seeding shaft
speed is calculated during
the calibration test
The actual seeding shaft speed is cal-
culated according to the forward speed
and is shown in the main menu
Forward speed [km/h] The set forward speed is
adjusted in the "Calibra-
tion" submenu
The actual forward speed [km/h] is
measured using the speed sensor and
is shown in the main menu.
The current seeding shaft speed should not undercut the 10 % dis-
played value to prevent deviations in the spread rate.
To Next Page
Loading...
