Amazone GreenDrill GD200-E - Switching off the Agitator Shaft Drive

Settings before commissioning
GreenDrill BAH0054-9 11.17
43
5.2 Switching off the agitator shaft drive
1. Switch off the control terminal.
The agitator shaft (1) should be run-
ning when using seeds that
 tend towards bridging.
 are very light,
e.g. grass.
2. Remove the protective cover (1).
2.1 Loosen and remove the 2 hexagonal
nuts (2) with the socket wrench (3).
3. Remove the round belt (1).
The agitator shaft is driven by the seeding
shaft via the round belt.
4. Install the protective cover.