Amazone GreenDrill GD200-E - Error Messages

GreenDrill control terminal 5.2
GreenDrill BAH0054-9 11.17
85
7.17 Error messages
Error message Description Remedy
Control voltage is too low Contact the service partner
Operating voltage
(at least 10 volt)
undercut,
see section "7.12", page 80
 Minimise the consumers
 Check the battery
 Check the alternator
 Check wiring
Operating voltage
(at least 10 volt)
undercut,
or
large voltage fluctuation,
see section 7.12, page 80
 Minimise the consumers
 Check the battery
 Check the alternator
 Check wiring
Operating voltage too high,
see section 7.12, page 80
Check the alternator
Alarm from the low level sensor Refill seed
Calibration value
"pulses per 100 m" is too high
Repeat the calibration,
(see section 7.7, page 75)