Amazone GreenDrill GD200-E - Setting the Blower Fan Speed on Tractors Without Flow Control Valve

Settings before commissioning
GreenDrill BAH0054-9 11.17
49
5.7.3 Setting the blower fan speed on tractors without flow control valve
Close the control valve (1) of the hydraulic control block before actu-
ating the tractor control unit to prevent damage when the blower fan
over-revs.
1. Close the control valve (1) of the GreenDrill.
1.1 Turn the control valve (1) of the
GreenDrill clockwise (-) up to the stop.
2. Run the tractor engine up to operating
speed.
3.
A
pply pressure on the control block with the
control valve (1).
3.1 Actuate the tractor control unit.
4. Set the blower fan to the required blower fan speed.
4.1. Read the scale value (2) from the following table.
Working width 3.0 m 6.0 m 12.0 m
Scale value
3 4 max.
Normal seed
2 3 4
Fine seed
4.2. Set the scale value (2) on the control valve (1).
4.2 Check the spread pattern on the field.
4.3 Optimise the spread pattern by adjusting the blower fan speed.