General safety instructions
16
GreenDrill BAH0054-9 11.17
2.10 Design changes
You may make no changes, expansions or modifications to the implement without the authorisation of
AMAZONEN-WERKE. This also applies when welding support parts.
Any expansion or conversion work shall require the written approval of AMAZONEN-WERKE. Only
use conversion and special equipment parts approved by AMAZONEN-WERKE so that the operating
permit, for example, remains valid in accordance with national and international regulations.
Vehicles with an official type approval or with equipment connected to a vehicle with a valid type ap-
proval or approval for road transport according to the German road traffic regulations must be in the
state specified by the approval.
WARNING
Risk of crushing, cutting, being trapped or drawn in, or impact
through the failure of support parts.
It is strictly forbidden to
drill holes in the frame or on the running gear,
increase the size of existing holes on the frame or the running
gear,
weld on load-bearing parts.
2.10.1 Spare and wear parts and aids
Immediately replace any implement parts which are not in a perfect state.
Use only original AMAZONE spare and wear parts or the parts cleared by AMAZONEN-WERKE so
that the operating permit retains its validity in accordance with national and international regulations. If
you use wear and spare parts from third parties, there is no guarantee that they have been designed
and manufactured in such a way as to meet the requirements placed on them.
AMAZONEN-WERKE shall accept no liability for damage caused by the use of non-approved spare
and wear parts or aids.
2.11 Cleaning and disposal
Handle and dispose of any materials used carefully, in particular
when carrying out work on lubrication systems and equipment, and
when cleaning using solvents.
2.12 User workstation
The implement may be operated by only one person sitting in the driver's seat of the tractor.
To Next Page
Loading...
