GreenDrill control terminal 5.2
GreenDrill BAH0054-9 11.17
67
7.3.3 During operation - Changing the spread rate
In the main menu, the seeding shaft speed and therefore the spread
rate can be changed in 1 %-increments during operation.
The spread rate is
increased by pressing the
button.
reduced by pressing the
button.
7.3.4 Pre-metering
If the seeding shaft rotates before beginning the field pass or when standing still on the field, press
and hold the
button. The blower fan starts running and after a few seconds, the seeding shaft be-
gins to rotate at the speed determined during calibration.
As soon as the button is released, the seeding shaft speed is adapted to the forward speed.
If the control terminal is connected to the 7-pin signal socket on the tractor or if the working position
sensor is active, the carrying implement must be in working position.
To Next Page
Loading...
