GreenDrill control terminal 5.2
GreenDrill BAH0054-9 11.17
99
7.20 Programming by your AMAZONE service partner
Many functions of the GreenDrill can be automated when the implement is connected to control termi-
nal 5.2. The functions can only be activated when the implement configuration is programmed on the
control terminal.
Have the programming performed by your AMAZONE service partner.
Before making any settings, switch off the blower fan motor and seed-
ing shaft motor.
7.20.1 Opening the program
1. Switch the control terminal off and then back on again (see page 65).
2. When switching on, press and hold the
button and also press the buttons until the
programming menu is opened.
You can navigate in the program with the following button combinations:
Buttons and are used to move around within the program.
Change the parameters using the buttons.
Confirm the programming with the button and exit the program.
If "AUTO" is selected in the following menus, the system automatical-
ly detects transmitting sensors.
To Next Page
Loading...
