GreenDrill control terminal 3.2
GreenDrill BAH0054-9 11.17
59
In case of a system fault
The control terminal shows the fault message in a coded form (see Table, unterhalb)
An acoustic signal is issued.
Fault mes-
sage
Cause Troubleshooting
01
Operating voltage is too low
Reduce consumer
Check the battery and cables
Check the alternator
02
Operating voltage is too high Check the alternator
03
Internal control voltage is too low Contact the service partner
04
The seeding shaft is blocked
Switch off the control terminal
Remove any foreign objects from
the seed drill and agitator shaft area.
05
The seeding shaft motor is without cur-
rent
Check the connector and cable
06
The seeding shaft motor is not rotating.
with proper connection
without being blocked.
Contact the service partner
07
The blower fan motor is blocked
Switch off the control terminal
Remove any foreign objects
from the blower fan area.
08
The wiring is incorrect or not even con-
nected
Check the connector and cable
09
The blower fan motor is not rotating.
with proper connection
without being blocked.
Contact the service partner
To Next Page
Loading...
