AMO Catalys OptiMedica - Mobile Patient Bed System Description; Introduction; Mobile Patient Bed Components

Part Number: 0160-6411, Rev A, 02/2019 Page 239 of 314
Software Release: cOS 5.00
1 Mobile Patient Bed System Description
This chapter contains the following major sections:
• 1.1 Introduction, page 239
• 1.2 Mobile Patient Bed Components, page 239
• 1.3 Mobile Patient Bed Specifications, page 246
• 1.4 Mobile Patient Bed Installation and Setup, page 247
1.1 Introduction
The Mobile Patient Bed is a patient support system used with the CATALYS® Precision Laser
System for Laser Cataract Surgery. It is designed for installation and use inside a sterile operating
room or in a non-sterile pre-op area within an ambulatory surgery center (ASC) or a hospital. The
Mobile Patient Bed can be located next to and wirelessly connected to the CATALYS® System to
position a patient for Laser Cataract Surgery.
When connected to the CATALYS® System, the Mobile Patient Bed is a fully integrated
subsystem. When not connected to the CATALYS® System, the Mobile Patient Bed can be used
to transport patients to and from operating rooms.
The Mobile Patient Bed is equipped with an on-board battery that is charged from an external
AC power source.
1.2 Mobile Patient Bed Components
The Mobile Patient Bed consists of the following components (see Figure 1.1 on page 240):
•Headrest assembly
•Backrest
•Seat
• Footrest
• Cushions
•Armrests
• DIN rails
•Column
•Base
•Casters
• Control pendant and holster
•Joystick control
• Auxiliary lock buttons
• Lock foot pedals
• Emergency stop button
• Reset button (not shown)
• Battery (not shown)
• AC power connection
• Control electronics and electrical
components (not shown)
• System software (not shown)
• Drape (optional; not shown)