Appendix A – Chapter 3 Mobile Patient Bed Maintenance
Page 274 of 314 Part Number: 0160-6411, Rev A, 02/2019
Software Release: cOS 5.00
Bluetooth Communication Error Messages
If the Bluetooth connection between the Mobile Patient Bed and the CATALYS® System fails, the
following error message displays at the top of the CATALYS® System screen:
Figure 3.5 Bed Connection Error Message
As instructed in the error message, verify patient positioning while the system attempts to
reconnect. If the Mobile Patient Bed and the CATALYS® System cannot automatically reconnect
after a few seconds, the following error message displays on the CATALYS® System screen:
Figure 3.6 Unrecoverable Communication Error Message
Press OK to clear the message.
NOTES
Refer to Instructions for Interrupted Treatments on page 200 for guidance on how to proceed
when treatment is interrupted.
For additional information on CATALYS® System error codes, refer to System Error Codes, Faults,
and Messages on page 214 and Appendix D – Software Error Code Table on page 299.
To Next Page
