AMO Catalys OptiMedica - System Error Codes, Faults, and Messages

Appendix A – Chapter 3 Mobile Patient Bed Maintenance
Part Number: 0160-6411, Rev A, 02/2019 Page 271 of 314
Software Release: cOS 5.00
Table 3.9 Wireless Quality of Service and Security
3.5 System Error Codes, Faults, and Messages
If the Mobile Patient Bed encounters an error or fault condition, laser treatment is interrupted;
the control pendant buttons blink; and/or an error message displays on the CATALYS® System
touchscreen.
NOTE
Refer to Instructions for Interrupted Treatments on page 200 for guidance on how to proceed
when treatment is interrupted.
Device
RF Wireless
Technology
Part Number
Operating
Frequencies
Operating
Distances
Industry
Standard
Quality of Service
and Security
CATALYS®
Mobile
Patient Bed
(MPB)
Bluetooth Microchip
RN42
2.400 to
2.4835 GHz
Up to 10
meters
Bluetooth
Specification
version 2.1 +
Enhanced
Data Rate
(EDR)
FCC CFR47
Part 15,
Subpart C
“Intentional
Radiators”
The MPB wireless
communication has
low latency, high
data integrity, and
is robust in the
presence of
interference as
defined by the
Bluetooth
specification.
Security
: The MPB
wireless
communication
channel is
configured to use
128 bit encryption.
Device System Wireless Functions, Capabilities, and Limitations
The CATALYS® Mobile Patient Bed (MPB) wirelessly and uniquely connects to a CATALYS® System
to allow the CATALYS® System the ability to enable and disable control features (joystick, pendant
buttons, etc.) and set motor speed limits based on the CATALYS® workflow.
Limitations during device operation
: The MPB must be used within the specified operating dis-
tance of the connected CATALYS® System or the wireless connection will automatically disconnect
and the MPB will revert to its disconnected functionality.