Appendix A – Chapter 4 Mobile Patient Bed Safety and Regulatory
Page 282 of 314 Part Number: 0160-6411, Rev A, 02/2019
Software Release: cOS 5.00
4.6 System Labels and Symbols
Part Number (located on System Information Label on bed base)
Serial Number (located on System Information Label on bed base)
Date of Manufacture (located on System Information Label on bed base)
Attention, Refer to Accompanying Documentation (located on System
Information Label on bed base). Applies to IEC 60601-1 Ed. 2.
Follow Instructions for Use (located on System Information Label on bed
base)
Class II Equipment (located on System Information Label on bed base)
Non-ionizing Radiation (located on System Information Label on bed base)
WEEE Symbol (located on System Information Label on bed base)
This symbol indicates that the equipment consists of electronic assemblies
and other components that may be subject to Directives 2012/19/EU, of the
European Parliament, which advises that Electrical and Electronic Equip‐
ment (EEE) must not be disposed of as normal domestic refuse. To prevent
environmental risks or endangerments by nonprofessional disposal, the dis‐
posal of this product, including any accessories, must comply with valid
practices as outlined in Directives 2012/19/EU, and local regulations. All
electronic components and systems should be returned to JJSV for disposal.
To Next Page
