Cell holder
Adjustable cell holder for microcells
20 Edition 09/2014 SPECORD S600 accessories
8 Adjustable cell holder for microcells
The holder for microcells is adjustable and can accept cells with radiation
heights of 8.5 and 15 mm.
The holder is designed for cells with the following dimensions:
Path length: 10 mm
Cell width: 12.5 mm
Radiation height 8.5 and 15 mm
Layout
2 Vertical adjustment screw
3 Horizontal adjustment knurled
head screw
4 Headed dowel to adjust the
radiation height
5 Cell duct
6 Knurled head screw for
fastening the holder
7 Spring catch
Fig. 8-1 Adjustable holder for microcells with variable radiation height
Installing the holder for microcells
1. Dependent on the radiation height of the microcell used, fit the headed
dowel (4) in the cell duct:
Radiation height 15 mm: Remove the headed dowel
Radiation height 8.5 mm: Screw the headed dowel in finger-tight
2. Slightly unscrew the locking screw at the holder (6) to prevent jamming
when inserting the holder.
3. Slide the cell holder with the guide from above onto the adapter plate of the
universal holder.
4. Tighten the locking screw to secure the holder.
Adjusting the cell holder
When the holder is used for the first time, or when the adjustment has been
changed, it is advisable to realign the cell.
1. Open the shutter to observe the transmitting beam.
On the Windows taskbar, click the [Start] button. Activate the menu
function Programs / WinASPECT / Service S600. This will bring up the
Service Check dialog box, the diagnostic utility of the device driver
software.
To Next Page
Loading...
Need help?
General
