Measurement with the cell changer
Carrying out measurements with the cell changer
34 Edition 09/2014 SPECORD S600 accessories
Manual start of
every position
Prior to the measurement of each cell a prompt is issued.
Only after this prompt has been acknowledged will the
actual sample measurement start.
This option can e.g. be used for kinetic measurements to
start the measurement immediately after adding the start
substance.
Slow time scan
If enabled the measuring data are recorded in the mode
"slow kinetics" (see section "Kinetic measurements with
the cell changer" p. 35).
Peltier
temperature-
controlled
To be activated when using a Peltier temperature-
controlled cell changer.
Using the buttons move the cell changer via software-control to a specific
position or start the adjustment:
Button Description
[Pos.1]
Move the cell holder to position 1.
[Pos. +1]
Move the cell holder to the next position.
[Adjustment]
Start the adjustment (see section "Adjusting the 6-cell
changer" p. 26)
(There is no adjustment for the cell carousel).
14.2 Carrying out measurements with the cell changer
Measurement without reference sample in the cell changer
11. Insert the reference sample into the first cell position. Activate the option 1st
position – reference.
The reference measurement is then integrated in the normal sample
measurement process.
12. Populate all remaining positions of the cell changer without gaps up to the
"last sample" position.
13. Start the sample measurement with in the toolbar or with the menu
command Measurement / Measurement.
To Next Page
Loading...
Need help?
General
