Cell holder
Notes for users
6 Edition 09/2014 SPECORD S600 accessories
This also applies to all service or repair work not carried out by authorized
service personnel. All warranty claims are also forfeited in this case.
Transport and storage!
Always use the packaging supplied for storage and transport!
Corrosion risk
Do not place the device immediately in the vicinity of aggressive vapor, e.g.
strongly corrosive acid or lye vapor! The vapor can corrode the terminals,
mechanical and optical components of the device.
Avoid the pollution of the sample chamber and accessories with strongly
corrosive substances! Use vapor-proof cells with sealing plug in this case.
Observe the specific instructions!
Instructions applying specifically for an accessory item are listed in the
corresponding chapter.
Caution! Contamination!
Never touch the optical mirrors of the accessories, if applicable!
Also observe the operating instructions and safety notices for the third party
system components supplied (e.g. liquid thermostats).
1.3 Caring for accessories
The accessories are predominantly maintenance-free. The following applies to
all accessories:
• Avoid contamination by handling sample substances with care.
• Wipe spilled samples or reagents immediately with an absorbent cloth.
• Do not expose the accessories to a corrosive atmosphere as it might
corrode.
• Where applicable, observe the additional care instructions for the
individual accessory items.
• Clean cells carefully after use.
1.4 The sample chamber design of the SPECORD S600
The sample compartment of the SPECORD S600 is open to three sides and
therefore easily accessible.
In most cases, accessories are fixed to the carrying rails by means of a simple
eccentric clamp.