To Next Page

To Previous Page

Index of Figures

4 Edition 09/2014 SPECORD S600 accessories

Fig. 15-20 Display and keys for temperature adjustment at the control unit ............. 62

Fig. 15-21 Temperature curve in the block and inside the cell for different cells ....... 63

Fig. 15-22 Heat exchanger – hose connections and compensation container .......... 64

Fig. 15-23 Heat exchanger – connections on the rear .............................................. 65

Fig. 16-1 Layout of the cartridge sipper system ...................................................... 68

Fig. 16-2 Flow cell with connected sample intake hose and pump hose ................ 69

Fig. 16-3 Complete hose kit for the cartridge sipper system ................................... 69

Fig. 16-4 Cartridge sipper system installed ............................................................. 70

Fig. 16-5 Measuring parameter configurations for the cartridge sipper system ...... 71

Fig. 17-1 Holder for solid samples .......................................................................... 74

Fig. 17-2 Installing the holder for solid samples in SPECORD S600 ...................... 74

Fig. 18-1 Absolute reflectance attachment ............................................................. 75

Fig.18-2 V- and W-shaped beam paths at the attachment .................................... 76

Fig. 18-3 Absolute reflectance attachment in the sample chamber ........................ 77

Fig. 19-1 Reflection attachment .............................................................................. 80

Fig. 19-2 Table tops for reflection attachment......................................................... 80

Fig. 19-3 Beam path in the reflection measuring attachment

(viewed from the front) ............................................................................. 81

Fig. 19-4 Reflection measuring attachment installed in the sample chamber ......... 81

Fig.19-5 Example for interference values at a reflection angle of

= 60° ........... 83

Fig. 20-1 Layout of the integrated sphere – Total view ........................................... 86

Fig. 20-2 Integration sphere in vertical and horizontal installation .......................... 87

Fig. 20-3 Screws for fastening the polychromator cover ......................................... 88

Fig. 20-4 Slit stop in front of polychromator ............................................................ 88

Fig. 20-5 Halogen lamp of integrating sphere ......................................................... 89

Fig. 20-6 Control unit installed in the SPECORD S600 .......................................... 90

Fig. 20-7 Optical path in transmission measurements ............................................ 92

Fig. 20-8 Optical path in reflectance measurements ............................................... 95

Fig. 20-9 Sample carrier with powdered sample ..................................................... 96

Fig. 21-1 Immersion sensor for transmittance......................................................... 98

Fig. 21-2 Adjustable holder to accept the optic fiber adapter .................................. 98

Fig. 21-3 Optic fiber adapter inserted in the sample chamber .............................. 100

Analytik Jena SPECORD S600 User Manual

Questions and Answers: