4-2 General Measurement Setups TD-SCDMA/HSPA+ Signal Analyzer
4-6 PN: 10580-00234 Rev. T 3GPP MG
RF Summary
The RF Summary displays the critical RF transmitter performance measurements in a table
format, without demodulating the TD-SCDMA/HSPA+ signal. The parameters that are
displayed in the RF summary table are Channel Power (dBm), Channel Power (RRC) (dBm),
Occupied Bandwidth (Hz), DwPTS Power (dBm), UpPTS Power (dBm), On/Off Ratio (dB),
Slot PAR (dB), Left Channel Power (dBm), Right Channel Power (dBm), Left Channel
Occupied Bandwidth, and Right Channel Occupied Bandwidth.
1. Press the Setup main menu key.
a. Press the Slot Selection submenu key. The Slot Selection window and menu open.
In the list window, use the rotary knob or press the touch screen to highlight Auto
or the desired slot (0 to 6), then press the Enter key.
b. Press the Trigger submenu key. The Trigger menu opens.
1. Press the Trigger Type submenu key to toggle through the three trigger types: No
Trig, GPS, and Ext. The active state is underlined on the face of the submenu key.
2. Press the Ext Trigger Polarity submenu key to select either Rising or Falling trigger
edge.
3. Press the Back submenu key to return to the Setup menu.
c. Press the Uplink Switch Point submenu key. The numerical value on the face of
the submenu key turns red and is ready to be edited. Use the arrow keys or the
rotary knob to change the value. You can also use the numeric keypad, then press
Enter.
d. Press the More submenu key to continue with setups under the Advanced
Settings menu.
e. Press the Number of Carriers submenu key so that the desired number is
underlined.
f. Press the Back submenu key to return to the Setup menu.
2. Press the Measurements main menu key.
3. Press the RF Measurements submenu key.
4. In the RF Measurements menu, press the RF Summary submenu key to view the
primary RF measurements in a table.
To Next Page
Loading...
