MT8212E and MT8213E MM PN: 10580-00255 Rev. J 6-1
Chapter 6 — Battery Information
6-1 Introduction
The following information relates to the care and handling of the Anritsu battery pack and Lithium-Ion
batteries in general.
• The battery supplied with the Cell Master may need charging before use. Before using the instrument,
the internal battery may be charged either in the instrument, using either the AC-DC Adapter
(40-187-R) or the 12-Volt DC adapter (806-141-R), or separately in the optional Dual Battery Charger
(2000-1374).
• Use only Anritsu approved battery packs.
• Recharge the battery only in the Cell Master or in an Anritsu approved charger.
• When the Cell Master or the charger is not in use, disconnect it from the power source.
• Do not charge batteries for longer than 24 hours; overcharging may shorten battery life.
• If left unused a fully charged battery will discharge itself over time.
• Temperature extremes affect the ability of the battery to charge: allow the battery to cool down or warm
up as necessary before use or charging.
• Discharge the battery from time to time to improve battery performance and battery life.
• The battery can be charged and discharged hundreds of times, but it will eventually wear out.
• The battery may need to be replaced when the operating time between charging becomes noticeably
shorter than normal.
• Never use a damaged or worn out charger or battery.
• Storing the battery in extreme hot or cold places will reduce the capacity and lifetime of the battery.
• Never short-circuit the battery terminals.
• Do not drop, mutilate or attempt to disassemble the battery.
• Do not dispose of batteries in a fire!
• Batteries must be recycled or disposed of properly. Do not place batteries in household garbage.
• Always use the battery for its intended purpose only.
Warning
This equipment is supplied with a rechargeable battery that could
potentially leak hazardous compounds into the environment. These
hazardous compounds present a risk of injury or loss due to exposure.
Anritsu Company recommends removing the battery for long-term storage
of the instrument and storing the battery in a leak-proof, plastic container.
Follow the environmental storage requirements specified in the product
data sheet.
To Next Page
Loading...
