1-15 Battery Replacement General Information
1-8 PN: 10580-00250 Rev. K Cell Master UG
The battery that is supplied with the Cell Master may need charging before use. The battery
can be charged while it is installed in the Cell Master by using either the AC-DC Adapter or
the Automotive Cigarette Lighter Adapter. The battery can also be charged outside the
Cell Master with the optional Dual Battery Charger. Refer to “Battery Symbols” on page 2-13
for a description of battery symbols.
Figure 1-1. Battery Compartment Door
Note
Use only Anritsu Company approved batteries, adapters, and chargers with this
instrument.
Caution
When using the Automotive Cigarette Lighter Adapter, always verify that the
supply is rated for a minimum of 60 Watts @ 12 VDC, and that the socket is clear
of any dirt or debris. If the adapter plug becomes hot to the touch during operation,
then discontinue use immediately.
Note
Anritsu Company recommends removing the battery for long-term storage of the
instrument.
To Next Page
Loading...
