ANSER CODING INC. 45 A1 User Interface
Table 1-8. Detailed Printhead Settings Description
Option Description
Pre-purge
Firing ink drops to avoid nozzles dry out from the result of cartridge short-decap, when
printing in dry environments.
Auto: Automatically determine parameters for the ink cartridge inserted.
Custom: Manually set the time and level parameters to purge the nozzles.
- Interval: The time in seconds to start a purge cycle.
- Level: Refer to the frequency of pre-purge cycle. The higher the level, the shorter time
for each purge cycle.
Cartridge Idle Alert
Cartridge idle counter will increase when cartridge is in idle state (print on or off), and
trigger warning when reaching the wipe reminder value.
Auto: Apply default value according to the decap time of currently used ink.
Custom: Manually set the time.
Pre-heating
For ink cartridge H-A01 only. Heat the cartridge beforehand to facilitate smoother ink
ejection in low-temperature environments.
Note: For printhead related settings, please refer to Table 1-1 for Nozzle Row and Table 1-7 for DPI.
To Next Page
Loading...
