Operation
5-63
5
P/N 6525032M1 - X6
Floating position
(if equipped).
To operate the remote hydraulics in a float condition, turn
the lock control fully anti-clockwise.
This will allow the control lever to go completely forward
into the float position.
The remote hydraulic control levers can be locked out of
the float position. When using equipment for work where
the float position is not wanted, turn the lock control one
position clockwise so that the control lever cannot be
moved into the float position.
NOTE:Single action cylinders can be operated in a float or
no float position at the same time that the hitch is operated.
To Next Page
Loading...