Controls - Cab
3-29
3
P/N 6525032M1 - X6
Pedal Controls
1. CLUTCH PEDAL
The clutch pedal is used to temporarily disengage drive.
Use the clutch pedal when moving the tractor over short
distances. Use the clutch pedal to start the tractor moving
from stationary. Gradually and completely releasing the
clutch pedal for a controlled smooth start.
WARNING: DO NOT ride the clutch pedal when the
transmission is under load. Release the clutch pedal
completely within 5 seconds for improved clutch
service life. While the tractor is moving the transmis-
sion must always be in drive. Never allow the tractor
to coast downhill with the transmission in neutral or
with the clutch pedal depressed. To do so could result
in the operator not having full control of the tractor
and may result in personal injury.
2. THROTTLE PEDAL
3. BRAKE PEDALS - The left brake pedal stops the
left rear wheel and the right brake pedal stops the right
rear wheel.
WARNING: Extra weight and bad traction
conditions such as mud or ice increase your
stopping distance. Remember that liquid in
the tires, weights on the machine or wheels,
tanks filled with fertilisers, herbicides or in-
secticides; all these add weight and increase
the distance you need to stop. Do not exceed
maximum permitted operating weights on
axle or tractor.
4. BRAKE PEDALS INTERLOCK - Used to lock the
brake pedals together.
WARNING: Brake pedals must be locked
together for road travel. This will ensure
uniform brake operation and maximum stop-
ping ability.
To Next Page
Loading...