STwrench User Guide Pset
9836 4134 01 Edition 2.9 113 (326)
The beep emitted by the buzzer starts when the torque goes over the Cycle Start
value; it increases its signal when:
- Torque reaches 1
st
percentage
- Torque reaches 2
nd
percentage
- Torque and angle within the minimum and maximum limits; torque or angle
having reached the target value.
- Max torque or Max Angle is reached.
At the end of the tightening operation, two more beeps inform the operator of the
end of the operation, and if the final result is in the red area, the buzzer signal
remains steadily ON.
If Angle Peak is selected in the torque parameter in the Pset definition, the
buzzer signal works in the same way, but monitoring angle instead of torque.
Vibration
Activated together with the third row of LEDs, and remains active until the
torque applied to the wrench is released.
To Next Page
Loading...
Need help?
General
