Atlas Copco STwrench - Page 188

Offline Programming STwrench User Guide
188 (326) 9836 4134 01 Edition 2.9
Once the file is created, disconnect the STwrench and select File → Open (or double-click on File):
When the file is opened, it is possible to start programming the tightening programs and wrench
configuration:
For programming the tightening programs and other STwrench configuration, see the specific
chapters of this user guide.
STwrench
offline
Open the
file
Open the
file
Tightening
programs
Controller
configuration
QAT Node
configuration
Identifier
configuration
Offline
traces