Atlas Copco STwrench User Manual

STwrench User Guide Working with Power Focus
9836 4134 01 Edition 2.9 229 (326)
torque whose value is greater than the P119 value is applied, then an
event "loosening" is sent to the PF.
- When the operator has already started the tightening, and a
negative torque whose value is greater than the P119 value is
applied, then an event "loosening" is sent to the PF; the generated
result is forced to be NOK.
Set this parameter to zero to disable this function.
P120 Start final angle
Start final angle
P121 Measure angle to
Function not available with STwrench
P122 Final angle min
Min. angle
P123 Target angle
Target angle
P124 Final angle max
Max. angle
P128 Rehit angle
Check already tightened angle
P130 Soft start speed
P131 Step 1 speed
P133 Loosening speed
These parameters are not used by the STwrench. However, they
must be set in a consistent way in order not to produce errors. Set
them to any value that does not give an error.
P141 End time
End Cycle time
P144 Cycle abort time
Ratchet time
P150 Batch count
Batch count
P151 Batch size
Batch size
P152 Lock at batch done
Lock at batch done
P153 Max Coherent NOK's
Max coherent NOK result
P240 Max coherent NOK result
Max coherent NOK result
C502 Speed unit
This parameter must be always set to %.
Do not set it as RPM.
T270 Power Save Timeout
When the STwrench is working in Power Focus mode, this

Atlas Copco STwrench Specifications

General

Brand	Atlas Copco
Model	STwrench
Category	Tools
Language	English