STwrench User Guide Working with Torque Supervisor
9836 4134 01 Edition 2.9 243 (326)
NOTE: When the STwrench is programmed by Torque Supervisor, all the Psets, Multistages,
Jobs, results, and traces stored in the wrench memory are deleted. Connect the STwrench to
ToolsTalk BLM and save tightening programs (in the .ttb file) and results/traces if you wish to
NOTE: In this application, ToolsTalk BLM is optional. However, if you do not purchase it, you
will not be able to access all the STwrench settings defined via ToolsTalk BLM (as described in
chapter
STwrench Controller Setup). Neither will you be able to use the TAG Writer function.
For IRC-W connection, the ToolsTalk BLM is mandatory.
To Next Page
Loading...
