Atlas Copco STwrench User Manual

STwrench User Guide Working with the QATnode
9836 4134 01 Edition 2.9 255 (326)
The Source program and Sub source job defined here are the same as the parameters defined in the
STwrench Controller settings; they are replicated here for convenience. See the chapter Setting the source
for Pset/Multistage/Job selection.
For IRDA communication:
- Set the QATnode connection to IRDA.
- Select the desired Source program and Sub source job.
- Enable the Enable connection with QATnode.
- Click on Store.
For IRC-W communication:
- Set the QATnode connection to IRC-W.
- Select the desired Source program and Sub source job.
- Click on Store.
- Select IRC-W and configure as follows:

Atlas Copco STwrench Specifications

General

Brand	Atlas Copco
Model	STwrench
Category	Tools
Language	English