Working with the QATnode STwrench User Guide
288 (326) 9836 4134 01 Edition 2.9
Finally, go back to the Connection settings and enable the QATnode connection:
NOTE: If the QATnode is also used to print the tightening result on a STAR printer and/or to
interface with a remote device via the I/O connectors, set the printer report and/or I/O
configuration as described earlier this chapter.
In case of connection problems with ToolsNet, the QATnode Settings software allows you to enable and
view a log file useful for troubleshooting.
Connect the PC to the COM 2 port of QATnode, and execute the QATnode Settings software. Select and
open the PC COM port you are using:
To Next Page
Loading...
