Working with the API STwrench User Guide
294 (326) 9836 4134 01 Edition 2.9
• Keep alive timeout: Interval between keep-alive messages from the wrench; the default value (5
seconds) is recommended.
• Security Type: Select the same security type as your own wireless network. For EAP-TLS, refer
to the Appendix B – EAP-TLS Security Type for more information.
• Internet Protocol (TCP/IP): Select Enabled DHCP if your network uses the DHCP protocol
(and specify the DNS 1 and DNS 2 if they are not set automatically by the network). It is also
possible to set manually an IP address (with Sub mask and Gateway) to the STwrench, by
selecting Static IP, and then configuring the Device IP Config:
For IRC-W Dual Band radio module, if the Internet Protocol (TCP/IP) is set to Static IP, it
is possible to enable the TCP Listener (and port); in this mode the STwrench serves as
listener instead of sender, and vice versa the API serves as sender instead of listener;
therefore only one STwrench can interface with the API:
If the Internet Protocol (TCP/IP) is set to Static IP and DHCP server, the STwrench works
as DHCP server, which means that the STwrench assigns an IP address to the system
connecting to it:
The Advanced settings... allow you to set the band, channels and parameters for the IRC-W dual band
radio module. Set the following parameters according to your specific radio network and access point:
To Next Page
Loading...
Need help?
General
