AudioCodes 400HD Series - Troubleshooting AudioCodes Devices

400HD IP Phones Series - Teams Compatible
Administrator's Manual 110 Document #: LTRT-09960
Parameter Description
Global Configuration Example
http://192.168.2.1/<450HD>.cfg
The configuration file name is 450HD.cfg
The following syntax is available for DHCP Options
66/67:
 Option 66 must be a valid IP address or host
name of a TFTP server only.
 Option 67 must be the firmware name.
If Option 67 is absent, the phone requests for the
450HD.img image file. For example:
 Option 66: 192.168.2.1 or myTFTPServer
 Option 67: 450HD_2.0.9.img
Note:
 This parameter is applicable only when method
is configured to "Dynamic".
 It is recommended to leave the parameter at its
default value to avoid conflict with other DHCP
options settings.
provisioning/random_provisioning_time
Defines the maximum random number to start the
provisioning process.
This is used for periodic checking of firmware and
configuration files to avoid multiple devices from
starting the upgrade process at the same time. When
the device is meant to start the upgrade, the device
randomly selects a number between 1 and the value
set for random_provisioning_time and performs the
check only after the random time.
The valid range is 0-65535. The default value is 120.
provisioning/period/type Defines the period type for automatic provisioning:
 [hourly] Hourly - Sets an interval in hours.
 [daily] Daily (default) - Sets an hour in the day.
 [weekly] Weekly - Sets a day in the week and an
hour in the day.
 [powerup] On Power-up Only - The phone tries
to upgrade only after power-up.
provisioning/period/hourly/hours_interval
The interval in hours for automatically checking for
new firmware and configuration files.
The valid range is 1 to 168. The default is 24.
Note: This parameter is applicable only when type
is configured to "hourly".
provisioning/period/daily/time
The hour in the day for automatically checking for
new firmware and configuration files.
The format of this value is hh:mm, where hh is hour
and mm is minutes. For example, 00:30.
The default time is 00:00.
Note: This parameter is applicable only when type is
configured to "daily".