AudioCodes 400HD Series - Enabling Direct Voice Dialing; Table 3-24: Enabling Voice Dialing

400HD IP Phones Series - Teams Compatible
Administrator's Manual 72 Document #: LTRT-09960
3.4.6 Enabling Direct Voice Dialing
Users can use the AudioCodes VocaNOM voice dialing service to directly voice dial other
parties by vocalizing their name. Additionally, the phone numbers of parties who are voice-
dialed are displayed in the the Call Log from where users can redial. The feature powers up
efficiency in organizations, increases productivity and improves users’ telephony experience.
Users can configure a key which they can press and then vocalize the name of the party to
whose number the VocaNOM service will directly dial.
 To enable voice dialing:
 Open the Configuration File page (Management tab > Manual Update >
Configuration File) and configure the parameters using the table below as reference.
Table 3-24: Enabling Voice Dialing
Parameter Description
voip/services/vocanom_server/enabled Enables or disables the method on user phones.
[1] Enables the method ‘Use VocaNOM server
directly’ [0] Disables the method ‘Use VocaNOM
server directly’ (default)
voip/services/vocanom_server/ip_address
Defines the IP address of the VocaNOM server.
Default: 0.0.0.0
voip/services/vocanom_server/port
Defines the port number on the VocaNOM server.
Its value must match Transport Mode.
 5060 for UDP, TCP

5061
for TLS
voip/services/vocanom/transport_mode
Defines the Transport Mode for sending SIP
messages.
 TLS
 UDP

TCP
voip/services/vocanom/label
Defines the name of the key
configured as
VocaNOM
displayed in the idle screen, and the
name displayed in the screen that opens after
pressing the key. Default: VocaNOM
voip/services/vocanom/number
Defines the number to dial to the VocaNOM server.
Default: None
Note: All parameters must be configured for the user’s VocaNOM key to be activated.