AudioCodes 400HD Series - Configuring the Btoe TCP Port; Figure 4-19: TCP Port; Figure 4-20: AC Btoe TCP Port

400HD IP Phones Series - Teams Compatible
Administrator's Manual 146 Document #: LTRT-09960
4.12.6 Configuring the BToE TCP Port
You can opt to configure a different BToE TCP port to the default 9999, depending on the
requirements of your enterprise. For example, you may decide to change the BToE TCP port
to 5000 because your enterprise is using the default port of 9999, and 5000 is available. This
feature therefore provides enterprise administrators with more freedom in network
administration.
Note: If you decide to change the default BToE TCP port, you must update both the
PC/laptop and the IP phone with the new BToE TCP port number.
 To change the BToE TCP port on the PC/laptop side:
3. Click the AC (AudioCodes) taskbar icon; the menu shown in Figure 4-20 pops up.
4. Select Disconnect in the popup menu and then select Configuration > TCP Port.
Figure 4-19: TCP Port
5. From the AC BTOE TCP Port dialog that opens, configure the TCP Port:
Figure 4-20: AC BToE TCP Port
The valid range is 1 to 65535.
 To change the BToE TCP port on the IP phone side:
 In the Configuration File, change the 'lync/BToE/TcpPortNumber' parameter.
For example, lync/BToE/TcpPortNumber=5000.