AudioCodes 400HD Series - Enabling Paging; Table 3-38: Paging Parameters

400HD IP Phones Series - Teams Compatible
Administrator's Manual 86 Document #: LTRT-09960
3.4.17 Enabling Paging
This feature allows a live announcement to be made (paged) from a phone to a group of
phones, to notify a team (for example) that a meeting is about to commence at a certain
venue.
All Function Keys can be configured for paging, allowing the user to page multiple paging
groups.
Note: Applies to all phones. Does not apply to the HRS.
The paged announcement is multicast via a designated group IP address, in real time, on all
idle phones in the group, without requiring listeners to pick up their receivers. The name of
the group is displayed on phone screens when the paging call comes in. If the Barge-in
feature (see the next section) is disabled (default), recipients of the paging call who are in
calls can choose to reject it.
 To enable Paging:
 Open the Configuration File page (Management tab > Manual Update >
Configuration File) and configure the parameters using the table below as reference.
Table 3-38: Paging Parameters
Parameter Description
voip/services/group_paging/codec
Sets the required codec. All the codecs used for regular
calls can be used for paging. See Section 3.4.16.2 for
supported codecs. Default: G722_8000.
voip/services/group_paging/enabled
Enables or disables the paging feature.
 [0] = Disabled [Default]
 [1] = Enabled
voip/services/group_paging/end_income_pa
ging_timeout
Sets the timeout, i.e., how many milliseconds must
pass after receipt of RTP ends, before paging times
out. Default: 800 milliseconds (8 seconds).
voip/services/group_paging/group/n-
n/activated
Activates or deactivates for the pager and the paged
parties a Speed Dial configured as a paging key.
 [0] = Deactivated [Default]. Paging was deactivated
for the key configured as paging dial, so the key will
be a regular speed dial.
 [1] = Activated. Paging was activated for the key
configured as paging dial.
Note: n-n are the Functional Keys indexed in the
Configuration File.
voip/services/group_paging/group/n-n
/multicast_addr
Applies only if 'Key Type' is configured as PAGING.
Enter the paging group's multicast IP address. Default
= 224.0.1.0. For phones to be in a group, all must be
configured with the same multicast address.
Note: n-n are the Functional Keys indexed in the
Configuration File.