AudioCodes 400HD Series - Table 3-12: Ring Tone File URI in the Configuration File; Table 3-13: Ring Tones Parameter in the Configuration File; Uploading Ring Tones

400HD IP Phones Series - Teams Compatible
Administrator's Manual 60 Document #: LTRT-09960
3.3.5.2 Uploading Ring Tones
This section shows how to upload ring tones using the Configuration File.
Note:
• The ring tone file must be in WAV file format (A/Mu-Law, 8-kHz audio sample rate
and 8-bit audio sample size or PCM 16-kHz audio sample rate and 16-bit audio
sample size, Intel PCM encoding).
• For the phone to use an uploaded ring tone, select it in the phone’s screen (refer to
the phone’s User’s Manual).
 To define the Ring Tone File URI:
• Open the Configuration File page (Management tab > Manual Update >
Configuration File) and use the table below as reference.
Table 3-12: Ring Tone File URI in the Configuration File
Parameter Description
provisioning/ring_tone_uri
The URI for retrieving the ring tones file. The ring
tones can be compressed to zip or tgz files and
provided to the phone during provisioning.
For example: provisioning/ring_tone_uri=tones.tgz
Note:
 The ringtone file is downloaded only after boot up,
and not periodically.
 If the tones file is new, the phone updates the
information, but does not reboot.
 To select Ring Tones:
• Open the Configuration File page (Management tab > Manual Update >
Configuration File) and use the table below as reference.
Table 3-13: Ring Tones Parameter in the Configuration File
Parameter Description
personal_settings/lines/0/ring_tone
Define the ring tone name.
Default Range: Ring01 - Ring11.
Default Selection: Ring01.
Alternatively, you can select the name of a previously
uploaded file, as in the example above (tones.tgz).