AudioCodes 400HD Series - Configuring VLAN Settings; Table 3-4: VLAN Parameters Description

Administrator's Manual 3. Manual Configuration of a Single IP Phone
Version 3.4.4 49 400HD IP Phones Series - Teams Compatible
3.1.3 Configuring VLAN Settings
VLAN settings can be configured using the Web interface, Configuration File, or the phone's
screen.
 To configure the phone’s VLAN settings:
1. Open the Configuration File page (Management tab > Manual Update >
Configuration File).
2. Configure using the table below as reference.
Table 3-4: VLAN Parameters Description
Parameter Description
network/lan/vlan/mode Determines the VLAN mode of operation.
 [Disable] Disable
 [Manual] Manual Configuration of LAN - Static
configuration of VLAN ID and priority
 [CDP] Automatic Configuration of VLAN - VLAN
discovery mechanism based on Cisco Discovery
Protocol (CDP)
 [LLDP] Automatic Configuration of VLAN - VLAN
discovery mechanism based on LLDP.
 [CDP_LLDP] Automatic Configuration of VLAN
(default) - VLAN discovery mechanism based on
LLDP and Cisco Discovery Protocol (CDP). LLDP
protocol is with higher priority.
network/lan/vlan/period
The time period in seconds between discovery
messages when configured to CDP, LLDP or CDP and
LLDP.
The default value is 30.
network/lan/vlan/id
Only displayed when the 'VLAN Discovery Mode'
parameter (above) is configured to Manual.
The valid range is 0 to 4094. The default VLAN ID is 0.
network/lan/vlan/priority
Only displayed when the 'VLAN Discovery Mode'
parameter (above) is configured to Manual.
Defines the priority of traffic pertaining to this VLAN.
The valid range is 0 to 7 (where 7 is the highest
priority). The default VLAN priority is 0.
 To configure the phone’s VLAN settings from the phone's screen:
1. Press the phone's MENU hard key when the screen is in idle display and then in
the Menu screen that opens, navigate to and select the Administration option.
2. Enter the same password you use to access your PC, and then OK; the
Administration menu opens.
3. Select Network Settings and in the Network Settings screen that opens, navigate
to and select VLAN Settings.
4. For 'VLAN mode', press the navigation control's left or right rim to choose either
DISABLE, MANUAL, CDP, LLDP, or CDP_LLDP.
5. If you choose MANUAL, enter 'VLAN ID' and 'VLAN Priority'.
6. If you choose CDP, LLDP, or CDP_LLDP, you can configure an Interval.