AudioCodes 400HD Series - Configuring Disconnect if Handset On-Hooked after Putting Call on Hold; Table 3-33: Disconnect if Handset On-Hooked after Call Put on Hold

Administrator's Manual 3. Manual Configuration of a Single IP Phone
Version 3.4.4 79 400HD IP Phones Series - Teams Compatible
3.4.15 Configuring Disconnect if Handset On-Hooked after Putting Call
on Hold
This section describes how to configure the phone so that when using the handset in a call,
if the call is put on hold and the handset is then on-hooked, audio switches to the speaker
and the call is not disconnected.
To maintain backward compatibility, users can set the ini file parameter
'voip/onhook_disconnect_when_held/enabled' to 1. This causes the call to be disconnected
in the above scenario, as it was in earlier versions.
 To configure this:
• Use the table below as reference.
Table 3-33: Disconnect if Handset On-Hooked after Call Put on Hold
Parameter Description
voip/onhook_disconnect_when_held/enabled
When using the handset in a call, if the handset is on-
hooked after putting the call on hold, the call is not
disconnected and the audio is switched to the
speaker. To maintain backward compatibility, users
can set 'voip/onhook_disconnect_when_held/enabled'
to 1. This causes the call to be disconnected in the
above scenario, as it was in earlier versions.
 [0] Disable (default). When using the handset in a
call, if the handset is on-hooked after putting the
call on hold, the call is not disconnected and the
audio is switched to the speaker.
 [1] Enable. When using the handset in a call, if the
handset is on-hooked after putting the call on
hold, the call is disconnected.