Administrator's Manual 4. Configuring Microsoft Skype for Business Features
Version 3.4.4 123 400HD IP Phones Series - Teams Compatible
4 Configuring Microsoft Skype for Business
Features
This section shows how to configure Microsoft Skype for Business features.
4.1 Microsoft Screen Theme
Note: Applies only to the 450HD and C450HD phone.
The screen theme by default reflects Microsoft Skype for Business 2016 client look & feel
but network administrators can opt to switch from the default to the legacy by changing the
personal_settings/ui_theme parameter from MSFT_THEME to AUDIOCODES_THEME.
4.2 Configuring Phone Status and User Status Timeouts
Network administrators can configure how long it takes for the phone status to change from
'Inactive' to 'Away', using parameter lync/presence/state_change_timeout.
Network administrators can also configure how long it takes for the user's status to change
from 'Available' to 'Inactive', using parameter lync/presence/state_inactive_timeout.
Default for both parameters: 300 seconds (five minutes).
Range for both parameters: 300 seconds – 2073600 seconds (24 days).
4.3 Park Call
The IP phone lets users park a call, i.e., transfer a call to a "parking lot" for it to be picked up
on any other phone in the enterprise by a party who must dial a retrieval number in order to
retrieve it on that phone. The retrieval number is configured in the Skype for Business
server's parking lot parameter. The retrieval number can be changed if required.
To pre-configure Microsoft's Skype for Business server for park call capability, see:
http://technet.microsoft.com/en-us/library/gg399014.aspx
Refer to all subsections.
4.4 Music on Hold (MoH)
If a user puts a call on hold to answer an incoming call or to make another call, the party put
on hold can hear music played. The Play Music on Hold feature allows this. By default, the
Play MoH feature is not enabled in Skype for Business.
To enable the MoH feature on the Skype for Business server:
1. In the Skype for Business Server Management Shell, run the following command in
order to view the current settings of the client policy:
Get-CSClientPolicy Global
To Next Page
Loading...
