AudioCodes 400HD Series - Configuring Automatic Dialing; Table 3-21: Automatic Dialing Parameters

Administrator's Manual 3. Manual Configuration of a Single IP Phone
Version 3.4.4 69 400HD IP Phones Series - Teams Compatible
3.4.5.2 Configuring Automatic Dialing
This section shows how to configure Automatic Dialing using the Configuration File.
 To activate automatic dialing:
 Open the Configuration File page (Management tab > Manual Update >
Configuration File) and configure the parameters using the table below as reference.
Table 3-21: Automatic Dialing Parameters
Parameter Description
voip/dialing/auto_dialing/enabled
Determines whether automatic dialing is enabled (i.e.,
phone number is automatically dialed when you
off-hook the phone).
 [0] Disable (default)

[1]
Enable
voip/dialing/auto_dialing/timeout
Only displayed if the 'Activate' parameter is configured
to Enable. Defines the timeout (in seconds) before
automatic dialing occurs after the phone is off-hooked.
When set to 0, automatic dialing is performed
immediately.
 The valid range is 0 to 120. The default value is
15.
voip/dialing/auto_dialing/destination
Only displayed if the 'Activate' parameter is configured
to Enable. Defines a number that will be automatically
dialed when the phone is off-hooked.
The valid value can be up to 32 characters.