AudioCodes 400HD Series - Configuring Tones; Configuring CPT Regional Settings; Table 3-11: Regional Parameters

400HD IP Phones Series - Teams Compatible
Administrator's Manual 58 Document #: LTRT-09960
3.3.5 Configuring Tones
This section shows how to configure ring tones using the Configuration File and how to
upload them to the phone.
3.3.5.1 Configuring CPT Regional Settings
It’s important to match your phone’s Call Progress Tones (CPT) to the country in which your
phone is located. This section shows how to configure it.
 To configure regional location:
• Open the Configuration File page (Management tab > Manual Update >
Configuration File) and use the table below as reference.
Table 3-11: Regional Parameters
Parameter Description
voip/regional_settings/selected_country
Defines the country in which your phone is located. The
behavior and parameters of analog telephones lines
vary between countries. CPTs are country-specific. The
phone automatically selects the correct regional
settings according to this parameter. Supported
countries are:
 [Israel] Israel
 [China] China
 [France] France
 [Germany] Germany
 [Netherlands] Netherlands
 [UK] UK
 [Brazil] Brazil
 [Italy] Italy
 [Argentina] Argentina
 [Portugal] Portugal
 [Russia] Russia
 [Australia] Australia
 [USA] USA
 [India] India
voip/regional_settings/use_config_file_values
Enables the user-defined CPT. When this parameter is
enabled, the ‘selected_country’ parameter is not
relevant and the CPT values below can be determined
by the user.
 [0] - Disable (default)
 [1] - Enable
Call Progress Tones (CPT)
Note: Up to 10 CPTs can be configured (voip/regional_settings/call_progress_tones/0…9).
voip/regional_settings/call_progress_tones/
%d/enabled
Enables the specific CPT.
 [0] - Disable
 [1] - Enable
voip/regional_settings/call_progress_tones/
%d/name
Defines the name of the CPT.