AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 1125 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Table 62-65: Telephone Keypad Sequence Parameters
Parameter Description
Call Pickup Key
configure voip > sip-definition
settings > call-pickup-key
[KeyCallPickup]
Defines the keying sequence for performing a call pick-up. Call
pick-up allows the FXS endpoint to answer another telephone's
incoming call by pressing this user-defined sequence of digits.
When the user dials these digits (e.g., #77), the incoming call from
another phone is forwarded to the user's phone.
The valid value is a string of up to 15 characters (0-
9, #, and *). By
default, no value is defined.
Note:
 Call pick-up is configured only for FXS endpoints pertaining to
the same Trunk Group.
 The parameter is applicable only to FXS interfaces.
Prefix for External Line
[Prefix2ExtLine] Defines a string prefix (e.g., '9' dialed for an external line) that
when dialed, the device plays a secondary dial tone (i.e., stutter
tone) to the FXS line and then starts collecting the subsequently
dialed digits from the FXS line.
The valid range is a one-character string. By default, no value is
defined.
Note:

You can enable the device to add this string as the prefix to the
collected (and sent) digits, using the parameter
AddPrefix2ExtLine.
 The parameter is applicable only to FXS interfaces.
configure voip > gateway
manipulation settings > prefix-2-
ext-line
[AddPrefix2ExtLine]
Determines whether the prefix string for accessing an external line
(defined by the parameter Prefix2ExtLine) is added to the dialed
number as the prefix and together sent to the IP destination (Tel-
to-IP calls).
 [0] = Disable (default)
 [1] = Enable
For example, if the parameter is enabled and the prefix string for
the external line is defined as "9" (using the parameter
Prefix2ExtLine) and the FXS user wants to make a call to
destination "123", the device collects and sends all the dialed
digits, including the prefix string, as "9123" to the IP destination
number.
Note: The parameter is applicable only to FXS interfaces.
Hook Flash Parameters

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English