User's Manual 1126 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
Flash Keys Sequence Style
configure voip > gateway dtmf-
supp-service supp-service-
settings > flash-key-seq-style
[FlashKeysSequenceStyle]
Determines the hook-flash key sequence for FXS interfaces.
 [0]
Flash hook = (Default) Only the phone's flash button is used
for the following scenarios:
During an existing call, if the user presses the flash button,
the call is put on hold; a dial tone is heard and the user is
able to initiate a second call. Once the second call is
established, on-hooking transfers the first (held) call to the
second call.
During an existing call, if a call comes in (call waiting),
pressing the flash button places the active call on hold and
answers the waiting call; pressing flash again toggles
between these two calls.
 [1] Sequence 1 = Sequence of flash button with digit:
Flash + 1: holds a call or toggles between two existing
calls
Flash + 2: makes a call transfer.
Flash + 3: makes a three-way conference call (if the Three-
Way Conference feature is enabled, i.e., the parameter
Enable3WayConference is set to 1 and the parameter
3WayConferenceMode is set to 2).
 [2] Sequence 2 = Sequence of flash button with digit:
Flash only: Places a call on hold.
Flash + 1:
1) When the device handles two calls (an active and a held
call) and this key sequence is dialed, it sends a SIP BYE
message to the active call and the previously held call
becomes the active call.
2) When there is an active call and an incoming waiting
call, if this key sequence is dialed, the device disconnects
the active call and the waiting call becomes an active call.
Flash + 2: Places a call on hold and answers a call-waiting
call, or toggles between active and on-hold calls.
Flash + 3: Makes a three-way conference call. This is
applicable only if the Enable3WayConference parameter is
set to 1 and the 3WayConferenceMode parameter is set to
2, and the device houses the MPMs. Note that the settings
of the ConferenceCode parameter is ignored.
Flash + 4: Makes a call transfer.
Note: The parameter is applicable only to FXS interfaces.
Flash Keys Sequence Timeout
flash-key-seq-tmout
[FlashKeysSequenceTimeout]
Defines the Flash keys sequence timeout - the time (in msec) that
the device waits for digits after the user presses the flash button
(Flash Hook + Digit mode - when the parameter
FlashKeysSequenceStyle is set to 1 or 2).
The valid range is 100 to 5,000. The default is 2,000.
Keypad Feature - Call Forward Parameters
Forward Unconditional
configure voip > gateway dtmf-
supp-service supp-service-
settings > fwd-unconditional
[KeyCFUnCond]
Defines the keypad sequence to activate the immediate call
forward option.
Forward No Answer Defines the keypad sequence to activate the forward on no
To Next Page
Loading...
Need help?
General
