User's Manual 802 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Tab Field Description

"IP": Call made from IP side
Source Tel Number Telephone number of the caller.
Destination Tel Number Telephone number of the called party.
Redirect Calling Number Telephone number of the redirected number.
Remote Signaling IP IP address used for SIP on the IP side.
Remote RTP (IP:Port) IP address and port used for RTP on the IP side.
Call Establishment Duration Length of time (in seconds) it took to establish the
call.
Call Duration Call duration (in seconds) from when call was
established.
Call State Current state of the call:
 "IDLE": No call.
 "SETUP": Signaling to setup call (SIP INVITE).
 "ALERT": Ringing at remote end (SIP 180
Ringing).
 "RINGBACK": Ringback played to port.
 "SESSION": Call has been answered and is
established.
 "RELEASE": Call has been terminated (SIP
200 OK).
Fax State Currently, not in use.
Coder + PTime Coder and packetization time used for the call.
Call Type Type of call:
 "Voice": Voice call
 "Fax": Fax call
Call Establishment Method Mode of call:
 "Normal": No early media during SIP session
establishment (before call accepted).
 "EarlyMedia": Media sent (e.g.,
announcements) before call accepted by
called party.
DTMF Selected Method for Tx/Rx DTMF Transport method used for the call. For
configuring the transport method, see
''Configuring DTMF Transport Types'' on page
191.
Basic
Channel Identifier: Channel identifier number.
Status Status of port:
 "Inactive": No call
 "Active": Active call
Call ID See above.
Endpoint ID ID of endpoint:
 "Not Available"
Call Duration Call duration (in seconds) from when call was
To Next Page
Need help?
General
