4. Configure the parameters as required. For a description of the parameters, see the
table below.
5. Click Submit; the entry is added to the Time Band table for the relevant Cost Group.
Table 14-4: Time Band Table Description
Parameter Description
Index
[CostGroupTimebands_TimebandI
ndex]
Defines the table index entry.
Start Time
[CostGroupTimebands_StartTime]
Defines the day and time of day from when this time band is
applicable. The format is ddd:hh:mm (e.g., sun:06:00), where:
ddd is the day (i.e., sun, mon, tue, wed, thu, fri, or sat)
hh and mm denote the time of day, where hh is the hour
(00-23) and mm the minutes (00-59)
End Time
[CostGroupTimebands_EndTime]
Defines the day and time of day until when this time band is
applicable. For a description of the valid values, see the
parameter above.
Connection Cost
[CostGroupTimebands_Connectio
nCost]
Defines the call connection cost during this time band. This is
added as a fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a
decimal).
Minute Cost
[CostGroupTimebands_MinuteCo
st]
Defines the call cost per minute charge during this timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a
decimal).
To Next Page
Loading...
Need help?
General
