AudioCodes MediaPack MP-118 User Manual

Version 6.6 423 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description
When the Native VLAN ID is different to any value in the 'VLAN
ID' column in the table, untagged incoming traffic is discarded
and all outgoing traffic is tagged.
The default Native VLAN ID is 1.
Note: If this parameter is not configured (i.e., default is 1) and
one of the interfaces has a VLAN ID set to 1, this interface is
still considered the ‘Native’ VLAN. If you do not wish to have a
‘Native’ VLAN ID and want to use VLAN ID 1, set this parameter
to a value other than any VLAN ID in the table.
[EnableNTPasOAM]
Defines the application type for Network Time Protocol (NTP)
services.
 [1] = OAMP (default)
 [0] = Control
Note: For this parameter to take effect, a device reset is
required.
[VLANSendNonTaggedOnNative]
Determines whether to send non-tagged packets on the native
VLAN.
 [0] = (Default) Sends priority tag packets.
 [1] = Sends regular packets (with no VLAN tag).
Note: For this parameter to take effect, a device reset is
required.
43.1.3 Routing Parameters
The IP network routing parameters are described in the table below.
Table 43-3: IP Network Routing Parameters
Parameter Description
Web: Disable ICMP
Redirects
[DisableICMPRedirects]
Determines whether the device accepts or ignores ICMP Redirect
messages.
 [0] Disable = (Default) ICMP Redirect messages are handled by the
device.
 [1] Enable = ICMP Redirect messages are ignored.
Static IP Routing Table
Web/EMS: IP Routing
Table
[StaticRouteTable]
Defines up to 30 static IP routing rules for the device. These rules can be
associated with IP interfaces defined in the Multiple Interface table
(InterfaceTable parameter). The routing decision for sending the
outgoing IP packet is based on the source subnet/VLAN. If not
associated with an IP interface, the static IP rule is based on destination
IP address.
When the destination of an outgoing IP packet does not match one of the
subnets defined in the Multiple Interface table, the device searches this
table for an entry that matches the requested destination host/network. If
such an entry is found, the device sends the packet to the indicated
router (i.e., next hop). If no explicit entry is found, the packet is sent to
the default gateway according to the source interface of the packet (if
defined).

AudioCodes MediaPack MP-118 Specifications

General

Brand	AudioCodes
Model	MediaPack MP-118
Category	Gateway
Language	English