AudioCodes MediaPack MP-118

User's Manual 386 Document #: LTRT-65422
MP-11x & MP-124
(4923 26) h323-call-origin = Originate
(4923 24) h323-conf-id = 02102944 600a1899 3fd61009 0e2f3cc5
37.4 Event Notification using X-Detect Header
The device supports the sending of notifications to a remote party notifying the occurrence
(or detection) of certain events on the media stream. Event detection and notifications is
performed using the SIP X-Detect message header and only when establishing a SIP
dialog.
For supporting some events, certain device configurations need to be performed. The table
below lists the supported event types (and subtypes) and the corresponding device
configurations, if required:
Table 37-4: Supported X-Detect Event Types
Events Type Subtype Required Configuration
CPT SIT-NC
SIT-IC
SIT-VC
SIT-RO
Busy
Reorder
Ringtone
SITDetectorEnable = 1
UserDefinedToneDetectorEnable = 1
Note: Ensure that the CPT file is configured with the
required tone type.
FAX CED (IsFaxUsed ≠ 0) or (IsFaxUsed = 0, and
FaxTransportMode ≠ 0)
modem VxxModemTransportType = 3
PTT voice-start
voice-end
EnableDSPIPMDetectors = 1
The device can detect and report the following Special Information Tones (SIT) types from
the PSTN:

SIT-NC (No Circuit found)

SIT-IC (Operator Intercept)

SIT-VC (Vacant Circuit - non-registered number)

SIT-RO (Reorder - System Busy)
There are additional three SIT tones that are detected as one of the above SIT tones:

The NC* SIT tone is detected as NC

The RO* SIT tone is detected as RO

The IO* SIT tone is detected as VC