AudioCodes MediaPack MP-118 User Manual

User's Manual 524 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
Reject Anonymous Calls Per Port Table
[RejectAnonymousCallPerPort]
This table parameter determines whether the device rejects
incoming anonymous calls. If enabled, when a device's FXS
interface receives an anonymous call, it rejects the call and
responds with a SIP 433 (Anonymity Disallowed) response.
The format of this parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable;
[\RejectAnonymousCallPerPort]
Where,
 Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
For example:
RejectAnonymousCallPerPort 0 = 0;
RejectAnonymousCallPerPort 1 = 1;
Note: This parameter is applicable only to FXS interfaces.
43.10.5.2 Call Waiting Parameters
The call waiting parameters are described in the table below.
Table 43-41: Call Waiting Parameters
Parameter Description
Web/EMS: Enable Call Waiting
[EnableCallWaiting]
Enables the Call Waiting feature.
 [0] Disable
 [1] Enable (Default)
If enabled, when an FXS interface receives a call on a busy
endpoint, it responds with a 182 response (and not with a 486
busy). The device plays a call waiting indication signal. When
hook-flash is detected, the device switches to the waiting call.
The device that initiated the waiting call plays a call waiting
ringback tone to the calling party after a 182 response is
received.
Notes:
 The device's Call Progress Tones (CPT) file must include a
Call Waiting ringback tone (caller side) and a call waiting
tone (called side, FXS only).
 The EnableHold parameter must be enabled on both the
calling and the called side.
 You can use the table parameter CallWaitingPerPort to
enable Call Waiting per port.
 For information on the Call Waiting feature, see Call Waiting
on page 251.
EMS: Send 180 For Call Waiting
[Send180ForCallWaiting]
Determines the SIP response code for indicating Call Waiting.
 [0] = (Default) Use 182 Queued response to indicate call
waiting.
 [1] = Use 180 Ringing response to indicate call waiting.

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet