AudioCodes MediaPack MP-118 User Manual

Version 6.6 561 MP-11x & MP-124
User's Manual 43. Configuration Parameters Reference
Parameter Description

[0] No (default)
 [1] Yes
For example, as a result of receiving the below INVITE, the
destination number after number manipulation is
cic+167895550001:
INVITE
sip:5550001;cic=+16789@172.18.202.60:5060;user=phone
SIP/2.0
Note: After the cic prefix is added, the IP to Hunt Group
Routing Table can be used to route this call to a specific
Hunt Group. The Destination Number IP to Tel Manipulation
table must be used to remove this prefix before placing the
call to the Tel.
Web: ENUM Resolution
CLI: enum-service-domain
[EnumService]
Defines the ENUM service for translating telephone numbers
to IP addresses or domain names (FQDN). For example,
e164.arpa, e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default
is "e164.arpa".
Note: ENUM-based routing is configured in the Outbound IP
Routing table using the "ENUM" string value as the
destination address to denote this parameter's value.
43.10.11 IP Connectivity Parameters
The IP connectivity parameters are described in the table below.
Table 43-58: IP Connectivity Parameters
Parameter Description
Web: Enable Alt Routing Tel to IP
EMS: Enable Alternative Routing
[AltRoutingTel2IPEnable]
Enables the Alternative Routing feature for Tel-to-IP calls.
 [0] Disable = (Default) Disables the Alternative Routing
feature.
 [1] Enable = Enables the Alternative Routing feature.
 [2] Status Only = The Alternative Routing feature is
disabled, but read-only information on the QoS of the
destination IP addresses is provided.
Web: Alt Routing Tel to IP Mode
EMS: Alternative Routing Mode
[AltRoutingTel2IPMode]
Determines the IP Connectivity event(s) reason for triggering
Alternative Routing.
 [0] None = Alternative routing is not used.
 [1] Connectivity = Alternative routing is performed if a ping
or SIP OPTIONS message to the initial destination fails
(determined according to the AltRoutingTel2IPConnMethod
parameter).
 [2] QoS = Alternative routing is performed if poor QoS is
detected.
 [3] Both = (Default) Alternative routing is performed if either
ping or SIP OPTIONS to initial destination fails, poor QoS is
detected, or the DNS host name is not resolved.
Notes:

QoS is quantified according to delay and packet loss

AudioCodes MediaPack MP-118 Specifications

General

Brand	AudioCodes
Model	MediaPack MP-118
Category	Gateway
Language	English