Parameter Description
EMS: RTCP XR Collection Server
Transport Type
[RTCPXRESCTransportType]
Defines the transport layer used for outgoing SIP dialogs
initiated by the device to the RTCP XR Collection Server.
[-1] Not Configured (default)
[0] UDP
[1] TCP
[2] TLS
Note: When set to [-1], the value of the SIPTransportType
parameter is used.
Web: RTCP XR Collection Server
EMS: Esc IP
[RTCPXREscIP]
Defines the IP address of the Event State Compositor
(ESC). The device sends RTCP XR reports to this server,
using SIP PUBLISH messages. The address can be
configured as a numerical IP address or as a domain name.
Web: RTCP XR Report Mode
EMS: Report Mode
[RTCPXRReportMode]
Determines whether RTCP XR reports are sent to the Event
State Compositor (ESC) and defines the interval at which
they are sent.
[0] Disable = (Default) RTCP XR reports are not sent to
the ESC.
[1] End Call = RTCP XR reports are sent to the ESC at
the end of each call.
[2] End Call & Periodic = RTCP XR reports are sent to
the ESC at the end of each call and periodically
according to the RTCPInterval parameter.
43.10 Gateway and IP-to-IP Parameters
43.10.1 Fax and Modem Parameters
The fax and modem parameters are described in the table below.
Table 43-36: Fax and Modem Parameters
Parameter Description
Web: Fax Transport Mode
EMS: Transport Mode
[FaxTransportMode]
Determines the fax transport mode used by the device.
[0] Disable = transparent mode
[1] T.38 Relay (default)
[2] Bypass
[3] Events Only
Note: This parameter is overridden by the parameter
IsFaxUsed. If the parameter IsFaxUsed is set to 1 (T.38 Relay)
or 3 (Fax Fallback), then FaxTransportMode is always set to 1
(T.38 relay).
Web: V.21 Modem Transport Type
EMS: V21 Transport
[V21ModemTransportType]
Determines the V.21 modem transport type.
[0] Disable = (Default) Disable (Transparent)
[2] Enable Bypass
[3] Events Only = Transparent with Events
Note: This parameter can also be configured in an IP Profile.
Web: V.22 Modem Transport Type
To Next Page
Loading...
