AudioCodes MediaPack MP-118 User Manual

User's Manual 520 Document #: LTRT-65422
MP-11x & MP-124
43.10.5 Supplementary Services Parameters
This subsection describes the device's supplementary telephony services parameters.
43.10.5.1 Caller ID Parameters
The caller ID parameters are described in the table below.
Table 43-40: Caller ID Parameters
Parameter Description
Caller ID Permissions Table
Web: Caller ID Permissions Table
EMS: SIP Endpoints > Caller ID
[EnableCallerID]
This table parameter enables (per port) Caller ID generation
(for FXS interfaces) and detection (for FXO interfaces).
The format of this parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled;
[\EnableCallerID]
Where,
 Index = Port number (where 0 denotes Port 1).
For example:
EnableCallerID 0 = 1; (caller ID enabled on Port 1)
EnableCallerID 1 = 0; (caller ID disabled on Port 2)
Note: For a detailed description of this table, see Configuring
Caller ID Permissions on page 271.
Caller Display Information Table
Web: Caller Display Information
Table
EMS: SIP Endpoints > Caller ID
[CallerDisplayInfo]
This table parameter enables the device to send Caller ID
information to the IP side when a call is made. The called party
can use this information for caller identification. The information
configured in this table is sent in the SIP INVITE message's
From header.
The format of this parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index =
CallerDisplayInfo_DisplayString,
CallerDisplayInfo_IsCidRestricted;
[\CallerDisplayInfo]
Where,
 Index = Port number, where 0 denotes Port 1.
For example:
CallerDisplayInfo 0 = Susan C.,0; ("Susan C." is sent as
the Caller ID for Port 1)
CallerDisplayInfo 1 = Mark M.,0; ("Mark M." is sent as
Caller ID for Port 2)
Note: For a detailed description of this table, see Configuring
Caller Display Information on page 268.
Web/EMS: Enable Caller ID
[EnableCallerID]
Enables Caller ID.
 [0] Disable (default)
 [1] Enable

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet